It is such a sublime feeling to be able to share with you my ZMR180 Mini Quad build. Initially, I began with the ZMR250 but I was looking to get something smaller in size as well that I could maneuver in tight spaces. Living in an urban locale, there are not a lot of open and wide spaces to fly but I am able to reach slightly tighter locations that are more suitable for smaller sized quadcopters.Read More »Building a ZMR180 Mini Quad
I recently installed the Furious FPV AcroWhoop V2 into my Tiny Whoop and synchronized with 18,000kV motors and 255mAh LiHV batteries. Believe me, it is a monster. It flies similar to a mini quadcopter. Initially, when I started flying Tiny Whoop Flight Controller, I bought the affordable Beecore. The Bellcore, despite its attractive features, came with certain deficiencies. Particularly, the Bind and Boot functions were supposed to be accessed using very tiny solder pads. It was quite a complex task to get it bound and configured.Read More »Best Tiny Whoop Flight Controller
FPV Model and Boris B. have developed the Betaflight F3 flight controller in collaboration with each other. The unique feature associated with the Betaflight F3 electronic printed circuit board is that it has been designed to utilize all of the functionalities associated with Betaflight.Read More »BetaFlight F3 Flight Controller Review
You can make your FPV setup unique by configuring an FPV ground station. If your quadcopter is equipped with a decent antenna and receiver, the FPV receiver integrated in the goggles is good enough to fulfill most of your flying needs. However, if you still desire to get enhanced video reception, you can also set up a ground-based FPV station to get better reception.Read More »Step by Step Guide to Setup FPV Ground Station
Owing to the massive popularity gained by drones, the spare FPV drone parts have become more and more affordable and decent FPV drone parts can be built without having to spend an arm and a leg. A couple of years back, it would cost around $30 to get a motor but now, you can get four quite powerful motors for an amount even lesser than this.Read More »Low Cost FPV Drone Parts
Initially, I felt that constructing a multirotor from scratch was going to be really hard. Then I went for PID tuning for Quadcopters. I believe that tuning can be quite complex since it is objective and subjective simultaneously. It is objective since it is related to mathematics. It is subjective since every pilot or drone enthusiast perceives it differently. It was one of the most difficult things for me to get a grasp on and to be honest, I still feel that I have a long way to go. I have been able to get a general idea of it, though, as I am able to tinker a little with my aircraft to improve my flight excursions. However, I am still quite far from getting my device perfectly tuned. Fortunately enough for most of us, there are plenty of PID tuning resources out there on the internet that has been placed there by some of the most expert pilots from amongst us. I have gone through them in detail and this has helped me to fiddle with my aircraft.Read More »PID Tuning for Quadcopters
